General Water Management
DocumentsDate added
Authors
D. Egarr, M.G. Faram, T. O’Doherty, D. Phipps and N. Syred
Abstract
A Hydrodynamic Vortex Separator (HDVS) has been modelled using Computational Fluid Dynamics (CFD) in order to predict the residence time of the fluid at the overflow and underflow outlets. A technique which was developed for use in Heating, Ventilation and Air Conditioning (HVAC) was used to determine the residence time and the results have been compared with those determined experimentally. It is shown that in using CFD, it is possible to predict the mean residence time of the fluid and to study the response to a pulse injection of tracer. It is also shown that it is possible to apply these techniques to predict the mean survival rate of bacteria in a combined separation and disinfection process.
Experimental investigation into solids re-entrainment in hydrodynamic vortex separatorshot!
06/17/2004
Authors
Dr D A Phipps, Dr R M Alkhaddar, Mr James Dodd, Dr M G Faram, Professor R Y G Andoh and Miss Cathryn Roberts
Abstract
Hydrodynamic Vortex Separators (HDVS) are used for removing solids from stormwater before discharge into watercourses and for Combined Sewer Overflow (CSO) and wastewater treatment. Their internal geometry generates flow patterns which promote solids separation and deposition in a hopper at the base. This study examines re-entrainment of captured solids at a range of flow rates, for four separator configurations. Dye-tracer experiments for one configuration have shown that the hopper region is a slow mixing zone (SMZ), with the rate of mixing and interchange with the main body of flow depending on overall flow rate. With the hopper part filled, dye tests showed minimal mixing of interstitially held water; supporting the view that removal of solids will occur only from the top of the bed. The onset and extent of reentrainment occurring when the hopper was full of sediment was found to depend on the configuration, with a general increase in its occurrence with increasing flows. The study highlights the importance of providing isolated zones for sediment collection and adequate shielding of the collected sediment.
Authors
Darrell A. Egarr, Michael G. Faram, Timothy O’Doherty, David A. Phipps, Nicholas Syred
Abstract
A Hydrodynamic Vortex Separator (HDVS) has been modelled using Computational Fluid Dynamics (CFD) in order to predict the residence time of the fluid at the overflow and underflow outlets. A technique which was developed for use in Heating, Ventilation and Air Conditioning (HVAC) was used. The results have been compared to those determined experimentally. It is shown that in using CFD, it is possible to predict the mean residence time of the fluid and to study the response to a pulse injection of tracer. It is also shown that it is possible to apply these techniques to predict the mean survival rate of bacteria in a combined separation and disinfection process.
By Robert Y.G. Andoh, Mike Faram and Dave Scott
Water industry officials throughout Europe – and in a growing number of municipalities in North America – tend to think of vortex valves as a novel technology for outlet flow control on a stormwater detention system. Most of these 17,000+ valves installed around the world are, in fact, implemented on stormwater detention schemes because use of a valve can reduce the required storage volume by up to 50% while still meeting the maximum discharge requirement. But vortex valves actually have many other uses in stormwater, wastewater and combined sewer systems. These versatile devices tackle a number of other problems, including erosion control, re-oxygenation of water and flow equalization in wastewater treatment plants.
Authors
D A Egarr, MG Faram, T O’Doherty
Abstract
A hydrodynamic vortex separator (HDVS) has been studied under laboratory conditions by using a specifically designed rig. Pressure tapping points placed at eight locations, six external and two internal, have revealed an even radial pressure distribution on the outer walls and central shaft. The ability of the HDVS to separate particulates has been studied. The particulates have been characterized by measurements of particle diameter and settling velocity, which have allowed efficiency cusps to be plotted against dimensionless groups used by other researchers. Owing to an unsatisfactory reduction of the data to a single curve by plotting the efficiency against dimensionless groups, an efficiency law has been determined based on the logistic equation and describes the separation efficiency in terms of the inlet flowrate, volume of the separator, and particle diameter and density.
